|
-
Wave Soldering Profiling
-
Thermal Profiling
-
Training
-
Contact Us
|
|
 |
|
Immersion Depth
- How do your Optimizers measure your immersion depth?
- What types of defects are caused when your immersion depth is too deep?
- What types of defects are caused when your immersion depth is too shallow?
- For 62 mil (1.6 mm) thick boards that are run directly on fingers, what is the range
of immersion depth readings you want to see prior to beginning production each shift?
- If your immersion depth readings are outside of this range, name at least three
steps you should take to correct this.
- Why is immersion depth not relevant until you have achieved board-to-wave parallelism?
- Why does verification of your immersion depth every shift eliminate improper immersion
depths as a cause of board defects? Why is verification necessary every shift rather
than weekly? Why do we consider this the most important question of this immersion
depth section?
|
 |
|
